RobotFuzz

OpenServo Version 3

• High speed 20MHZ design
• High precision positioning
• Advanced curve based motion profile engine
• Open source design and software
• Back EMF speed sensing

Power connector for the Open Source InterFace.

*Picture as illustration only. Actual product may vary

Suitable for use with socket housing OSIF 8 pin connector shell (OS-8-PIN-SHELL) and also the OSIF power connector (OSIF-2-POWER)

This 8 pin connector shell is suitable for connecting to the OSIF USB I2C interface, and also the OpenServo Version 2.

Remember to order the 4-8 x OSIF socket crimp pins (OS-8-PIN-SOCKET) to go with this.

*Picture for illustration only.

Hirose DF11-10 24-28AWG crimp connector Gold (Au)

Suitable for use with the Hirose DF11-10-2C connector on the OpenServo v3 platform

Hirose DF11-10 24-28AWG crimp connector Tin (Sn)

Suitable for use with the Hirose DF11-10-2C connector on the OpenServo v3 platform

Hirose Connector type DS11-10DS 10 pin 2mm pitch. Suitable for use with OpenServo v3.

Note: This does not come with socket pins. Please see the Connectors category for suitable Hirose contact pins or prewired cables.

Recommended Accessories

4 to 10 x Hirose DF11-10 Crimp pin Gold (HIR-SOC-24-28-GOL)
or
4 to 10 x Hirose 12" Crimp pin +wire Yellow (HIR-CAB-YE-12-28)
(available in various colours)

An Open Source InterFace is a USB to I2C converter.

This interface converts USB signals to the fast (400khz) I2C interface.

The OSIF is designed to control the OpenServo servo motor controller, but will serve as a generic USB to I2C interface.